Setting up PID Temperature Controller to be a PWM Controller for SSR
- PID Temperature Controller Applications
- 13 Oct, 2021
Setting up a temperature controller as an indicator
- PID Temperature Controller Applications
- 05 Mar, 2021
Setting up a temperature Controller as an indicator is as simple as setting the input to the correct Linear Voltage or Current such as 4-20mA, 0-20mA, 0-10V, 0-5V etc.
Setting up PCB1 Pattern Controller Program
- PID Temperature Controller Applications
- 19 Jul, 2019
In this blog article we walk you through setting up a Shinko PCB1 Series Temperature Controller for Ramp and Soak operation also referred to as step control sequence setting.
In this programming guide, our customer would like to ramp up as quickly as possible to 70 Deg C.
Setting up BC Series Controller for External Start/Stop in Fixed Point Control, or Program Run/Stop in a step sequence
- PID Temperature Controller Applications
- 11 Jul, 2019
Strange temperature offset behaviour in PID Controllers
- PID Temperature Controller Applications
- 13 Feb, 2019
Simple BC Series setup of one or two Setpoint(SV1,SV2), with High limit on Temperature.
- PID Temperature Controller Applications
- 12 Feb, 2019
0.2 Deg C Deviation using Hysteresis on Shinko BC Series Temperature Controllers
- PID Temperature Controller Applications
- 22 Jan, 2019
Setting up step control sequence in a BC Series Temperature Controller for Ramp and Soak
- PID Temperature Controller Applications
- 11 Jan, 2019
The wait value is used for if you set the timing too short, for example if in the cooler months it takes longer than X seconds to heat up
