In this blog article we walk you through setting up a Shinko PCB1 Series Temperature Controller for Ramp and Soak operation also referred to as step control sequence setting.

In this programming guide, our customer would like to ramp up as quickly as possible to 70 Deg C.

For the Basic setup of fixed point control see this article, and for Ramp and Soak Step Control Sequence see our

There may be a situation where you have set the input type, the setpoint(SV) and the controller will not reach the desired temperature. 

In this situation you should check Engineering mode...

To setup a simple single setpoint (SV) with with high limit for preventing user errro in increaseing he setpiint beyond the limits of the heating chamber. We will also extend further to setup more than one setpoint (SV) if required

In order to setup for very small temperature variation, you fist need to set the input sensor type as shown in our previous Read more 0